QR-Code mit ESP32 & Oled

Hello community,

Today I would like to present an interesting project: We generate a QR code, stored in the source code, with our ESP32Dev board and the AZ delivery 1.3 "Oled Display.

For this we need:
2 breadboards
1 ESP32 Dev module
1 1.3 "Oled
1 power bank (optional)

The wiring:

ESP32 NodeMCU OLED 1.3 "
GND GND
3.3V VCC
G22 SCK
G21 SDA

 

Libarys required:

Code:

 

#include <qrcode.H>
#include <SH1106.H>

SH1106  display(0x3c, 21, 22);
QRcode qrcode (&display);

void set up() {     Serial.begin(115200);     Serial.println("");     Serial.println("Generating ...");     display.init();     display.clear();     display.display();     // Initialize QRcode display using library     qrcode.init();     // create qrcode     qrcode.create("http://flyt.it/kundenservice-rueckmeldung");

}

void loop() { }

 

Modifications / work steps:

  • first we have that I2C address  of our display
  • Crafted a large breadboard
  • Adaptation of the display: The ESP8226 / 32 Oled SSD1306 Libary also supports the SH1106 controller
  • Ignore error message from QR-Libary about compatibility with ESP32 :-)

 

DisplaysEsp-32Projects for beginners

Leave a comment

All comments are moderated before being published

Recommended blog posts

  1. Install ESP32 now from the board manager
  2. Lüftersteuerung Raspberry Pi
  3. Arduino IDE - Programmieren für Einsteiger - Teil 1
  4. ESP32 - das Multitalent
  5. OTA - Over the Air - ESP programming via WLAN